To remove a line card, use the figure below or Figure 2 as a reference and follow these steps: 1.

Print Results.

Module temperature = +29. Sample Output: IOS-router#show hw-module subslot 0/2 transceiver 2 status.

show interface shows all interfaces (which may have a protocal attached, for example, IPv4).

There is no new command who shows you a table from the rx/tx signals of all interfaces, you need to search it one by one with the command.

. It seems like all GE-T should work but i tried the following models with no luck! P/N 30-1421-01. .

.

617 C Transceiver Tx supply voltage = 3292. To remove a line card, use the figure below or Figure 2 as a reference and follow these steps: 1. switch (config)# service unsupported-transceiver.

108: %TRANSCEIVER-6-INSERTED: SIP0/0: transceiver module inserted in GigabitEthernet0/0/0. The commands to show the DDM information of transceiver optics may vary among different switches.

.

"show inventory" shows the part ID of the SFP.

. .

and erial-no. Module temperature = +24.

switch#configure terminal.
I need some help as i am very frustrated with a a very simple situation here.
No surprise there that a device accepts a command and does fuck all with it.

Supported Hardware Components.

However, network administrators can perform onsite monitoring if they so choose.

Jun 14, 2022 · Router# show hw-module subslot 4/0 transceiver 2 status The Transceiver in slot 4 subslot 0 port 2 is enabled. 6 mVolts. .

Step 2 Step 3 Remove the dust plug from the CFP transceiver module. In the past Cisco IOS provided a command to view digital optical monitoring (DOM) “light” levels via the show interface transceiver command. The Cisco ASR 1000 Series Aggregation Services Routers are designed to send alarm notifications when problems are detected. I am trying to figure out how to get optical power levels from an ASR 1006 with a XFP-10GLR-OC192SR transceiver in a SPA-1X10GE-L-V2 slot. 9 mVolts Transceiver Tx bias current = 22906 uAmps Transceiver Tx power =. This means when transceiver is inserted in to this device, the device.

.

Module temperature = +41. 0 uVolts Transceiver Tx bias current = 4840 uAmps Transceiver Tx power = 349.

.

Disconnect and remove all interface cables from the ports; note the current connections of the cables to the ports on the line card.

P/N 30-1421-03.

the command.

Step 2 Step 3 Remove the dust plug from the CFP transceiver module.